This motor came to our station separately from the car, so it's hard to even tell which model of car we're talking about. However, judging by the markings on the motor itself, it appears to be a unit for one of the Peugeot or Citroen models, and if you take the hieroglyphics into account, it was made for the Chinese market. (It later turned out to be an Opel).
The car was involved in a minor accident, but after the accident, the engine stopped spinning, jammed. For this reason, the motor was removed and sent to us for repair. Initial inspection showed that the bearings were individually spinning and did not even seem to be affected, no noise. We will have to disassemble the motor to find the cause.
We unscrewed the covers from the motor and the bearing information was confirmed. However, the rotor is still firmly seated in the stator, not spinning. My intuition tells me that the root of the problem lies in the motor design. Here the motors are not asynchronous, as on Tesla, but, as on the previously repaired to us Korean-made cars, Kia/Hyundai, synchronous. Their difference – is the neodymium magnets used in the rotors. These magnets are so strong that the motor is difficult to work with – it constantly attracts all the objects that happen to be nearby.
It seems that this time that «object» was the stator itself. A hydraulic press had to be used to separate the two parts of the motor. And now the inseparable rotor and stator were finally separated, and we began to examine them. On the surface of the rotor we found a stain, which looked like rust rubbed off with sandpaper. However, there was neither rust nor moisture anywhere. There are similar marks on the stator too, plus
Surfacing on a few of the plates.
Probably as a result of the accident, due to loss of alignment, the rotor started touching the stator and therefore became magnetised. While the car was travelling, it was still spinning, but as soon as the motor stopped, the hot parts melted together. This version is also confirmed by spots of white colour on the inner surfaces of the covers – apparently from overheating.
We cleaned up all of the gouges and contact marks with sandpaper and a flap wheel for the grinder, smoothed, polished and cleaned all of the dust and chips with compressed air. After that we wrapped the rotor with thick polythene film to prevent it from being magnetised to the stator. An old water bottle was used to do this, so it was heated in the manner of heat shrinking to make it fit tightly to the metal.
The rotor wrapped in polythene went inside the stator easily, we then clamped one of the covers on to center it thus avoiding magnetization, removed the film, and put the second cover on. The motor spun easily by hand, so we considered the repair a success and returned it to the customer – that was the agreement. However, given some backlash after the accident, we advised him to replace the motor in due course.